Virtex-4 FPGA • Virtex-5 FPGA • PMC • DDR2 SDRAM

Virtex-5 FPGA • Virtex-4 FPGA • PMC • XMC • PCI Express • DDR3 SDRAM, DDR2 SDRAM

Based on the ADV212 codec devices suitable for on-the-fly compression • Virtex-4 FPGA • ADV212 • CODEC • JPEG2000

3U CompactPCI form factor • PowerPC MPC8545E @ 1.2GHz • up to 1GB DDR2-400 SDRAM with ECC • up to 1GB NAND Flash • Two Gigabit Ethernet ports • User FPGA /w dedicated SDRAM • Conduction cooling version available • Three ruggedization levels available

Small form factor COM Express carrier • Compact & Basic COM Express type-III Modules support • Two PMC extensions • Two Gigabit Ethernet • Four USB 2.0 ports • One SATA and eSATA ports • Graphical video interface (RGB, LVDS, S-video) • 12 VDC power supply

8-channel serial communication UART controller • RS-232 and RS 422/485 software programmable interfaces • Up to 6.25 Mbps data rate @ RS-422/485 • Up to 250 kbps data rate @ RS-232 • Half and full duplex modes support • Conduction cooling compatible • Industrial temperature range -40/+85 °C

Computer Box Concept based on COM Express • PowerPC processor MPC8347E • Up to 2 GByte DDR2 • Up to 1 GByte NAND Flash • Two PMC slots • Graphic controller (RGB, S-video, LVDS) • Two Gigabit Ethernet ports • Two USB 2.0 ports • One internal SATA, one eSATA • 12 VDC power supply

PowerQUICC II Pro MPC8347E 400 MHz • Up to 2GB DDR2 SDRAM on SO-DIMM socket • Up to 1GB NAND Flash • Two S-ATA ports • 2D/3D graphic accelerator • Two Gigabit Ethernet ports • Two USB 2.0 Full-Speed ports • Available extended temperature range (-40/+85°C)

Supports 65nm Intel μFC-PGA 478 / μFC-BGA 479 Core 2 Duo CPU • Intel GME965 / ICH8-M chipset • One 200-pin SODIMM up to 2 GB DDR2 SDRAM • Dual View, 2-CH LVDS, TV-out, HDTV • Supports 5.1-CH / 7.1-CH Audio with S/PDIF • 1 EIDE, 2 SATA, 1 Type I/II CF, 1 Mini PCI • 2 COM, 4 USB 2.0, 8-bit GPIO

Supports 65nm Intel μFC-PGA 478 / μFC-BGA 479 Core 2 Duo CPU • Intel GME965 / ICH8-M chipset • One SODIMM up to 2 GB DDR2 SDRAM • 2-CH LVDS, Dual View • Broadcom BCM5787 Gigabit LAN • 4 PCI, 5 PCIe x 1, 1 PCIe x 16 • 3 SATA II, 8 USB 2.0, 8-bit GPIO

ASIC, Embedded Systems, Application Software domains

1. Control Unit: maskable interrupt; non-maskable interrupt; set overflow flag for external numeric processing device; Synchronization signal for single cycle execution; ready state input for DMA interfacing • 2. 8-bit Instruction Decoder: 56 instructions;151 opcodes • 3. 8-bit Arithmetic-Logic Unit: decimal and binary arithmetic operations; logical operations; logical shift operations • External Memory interface: addressing up to 64 KB of: external program memory; external data memory; externali input/output space; 13 addressing modes; de-multiplexed Address/Data Bus to allow easy connection to memories; RDY signal for interfacing with slow RAM/ROM modules or DMA wait cycles to access slow ROM

1. Control Unit: 9-level deep and 1-byte wide instruction queue • Independent instruction execution stages allow instructions to overlap • Arithmetic Logic Unit: - 16-bit arithmetic and logical operations, Boolean manipulations, 16 x 16-bit multiplication and 32-/16-bit division • Memory interface: memory interface compliant with the 80c186xl device, 20-bit addressing space, 1 MB memory space divided into 64 KB logical segments, Internal and external control of the length of memory access to instruction and data, 64 KB I/O space • Direct Memory Access (DMA) Controller • Two separate, fully functional DMA channels • External transfer initiation by DRQn pins • Linear access to 20-bit memory addressing space • Programmable Interrupt Controller, 5 external interrupt lines, including NMI; 5 internal interrupts generated by the peripherals set

Dimensions for the IP interface combined with the MM2 radio are 101 x 51 x 13 millimeters with a weight of 42 grams • Low signal performance: RISC-based signal demodulation with matched filter • Sensitivity is specified and guaranteed • GaAs FET RF front end with multi-stage Surface-Acoustic-Wave (SAW) filters has a combination of overload immunity and sensitivity • Selectivity is specified and guaranteed • Industrial grade high-speed Ethernet • Supports TCP, industrial grade wireless security and serial communications, all in one package • Selectable speeds: 115.2 KBPS to 1.23 MBPS • Single MM2 or MM2 Ethernet can be used in a security network as a master, slave, repeater or master/slave unit • High noise immunity • Offers superior performance in noise-congested environments • Line-of-sight range to 60 miles at standard data rates and 30 miles at high-speed data rates • FreeWave’s proprietary spread spectrum technology prevents detection and unauthorized access; offers 128-bit AES encryption • 100 percent tested for RF performance from -40 ºC to +85 ºC

4-channel, 250 MHz 12-bit ADC • Transformer-coupled inputs • 50 ohm input impedance • Xilinx Virtex-5 SX95T user-Programmable FPGA • 62 dB SNR, 76 dB SFDR • PCIe x4 interface, 1.25 GB • GC5016 Digital Down-Converter • QDR II SRAM 16 MBytes • Hardware Development Kit (HDK) included • Windows and Linux Software Development Kits

Power and flexibility of the Virtex-5 FXT with build options for SXT and LXT for demanding defense and aerospace applications • Xilinx Virtex-5 FPGA - FX100T with PPC440 hard cores or SX95T or LX110T • External Memory - QDR 2 SRAM, DDR2 SDRAM, SPI Flash • Rear I/O - VITA 42.3 PCIe gen2 (to 5 GHz) or VITA 42.2 Serial RapidIO build option, RocketI/O to 6.5 GHz via GTX ports; LVDS, GPIO, GbE, Serial Ports • Front I/O - GbE, Serial, LVDS, GPIO • VWRAP - EDK and ISE project with tested cores; VBIT - Built-In-Test • 5 ruggedization options

PCI Express x4 external cable connector on front panel • When coupled to its VMEx64 companion, the PEV1100, the local host shall perform automatic configuration as well address mapping and interrupt ID • A set of user friendly software tools running under Linux and Windows are provided in order to: • Configure the board registers to allow transparent access to VME, PMC and shared memory from the user application • - perform data transfer using the 4 channel DMA engine of the PEV1100

Consolidates industrial computer, router, PoE, and managed switch • RISC, 64 MB SDRAM, fanless • Operating temperature -40 °C to +80 °C • Linux, Modbus gateway for ready to use • 3. 2 USB, SD card for control program upgraded • Industrial Router (five Ethernet ports) • Free combination between WAN and LAN • IP routed, static routing, NAT, firewall, DMZ • Industrial PoE • 4 ports, IEEE802.3af 15.4 W • PoE scheduling • Industrial Managed Switch • QoS • VLAN (802.1Q, port-based) • Industrial Serial Device Server • Two RS-232 ports, two RS-232/422/485 ports • Virtual COM • Industrial Digital I/O Controller • 4 DI and 4 DO • DIO scheduling

8 MDI/MDIX 100 BT PORTS • MICREL 8842 MAC • PC/104 Feed-through • Wire speed switch • +5V only •3 link status LEDS per port • Available without MAC port • RoHS Compliant available

PC/104-PlUs to MiniPCI • Allows up to 4 MiniPCI type III cards • Local 3.3V regulator for MiniPCI • Occupies only 1 PC/104-Plus slot • Selectable PCI slots 0-3 Universal (5V or 3.3V BUS) • Connector for LED status signals • Supports routing of second interrupt • Two MiniPCI cards on the front and back • Made in USA - local support • RoHS Available

Uses 1M or 1.5M gate Xilinx FPGA • All I/O bits are 5V tolerant • Bus Master capability • 96 I/O Bits • 24MA output drive • Four 50 pin connectors • 11 LED status indicators •FPGA download from Host • RoHS Compliant Available

SDR, DDR, DDR2 and Mobile DDR SDRAM memory devices • Up to 6 Avalon local bus port interfaces • Avalon Pipelined and Burst transfers • Avalon local bus width from 8 to 128-bits • Configurable FIFO depth: 16 to 2048 bytes • Intelligent SDRAM burst caching minimizes wait-states

Designed in conjunction with Altera• Altera EP3C120 Cyclone III FPGA • 256 MB 64-bit DDR2 memory • 4-lane PCIe PHY • HDMI Receiver / Transmitter Daughter Card • Quad Link LVDS supports up to 1080p 100/120 LCD Display Panel • Suite of HD video processing IP reference designs based on Altera's Avalon® VIP system interconnect framework

SD Card for local recording • 1 way & 2 way audio recording • 4 to 5 times higher resolution than normal surveillance cameras. • Rugged and Valal proof • Outdoor rated • Megapixel Resolution

Two piggyback board expansion connectors: one compatible with DP1, the other with DP3 • User interface via a digital encoder for analogue control functions, two hexadecimal LED displays, 5 Pushbuttons and an interface to an Optrex LCD display • Optical audio transmitter and receiver • USB interface • Infra-red receiver.• Serial EEPROM for standalone operation

5 pre-set video patterns allow comprehensive testing of video systems • Small resource footprint for use in the smallest FPGAs • Pattern memories are programmable

2036 logic elements allows multiple encoders in the smallest of FPGAs • High quality video output: <1 percent DG and <1deg DP, <1 percent K-factor and <-65dB SNR • Output is up-sampled 27 MHz straight binary digital composite video • Switchable sin x/x filter • 3-year unlimited use license (renewable) • Other license options available

3U CompactPCI form factor • Available in conduction-cooled and air-cooled versions • Rugged conduction-cooled carrier versions follow the IEEE 1101.2 specification and operate with ANSI VITA 20 compliant XMC modules. Conformal coating is optional • XMC interface (ANSI VITA 42.0) provides high-speed, low latency, deterministic data flow to an industry standard mezzanine • Compatible with PMC and ePMC (Solano) modules • Xilinx Virtex-4 technology for wideband processing and low power operation • FPGA “wrapper” abstracts board-level logic to accelerate FPGA firmware development • TMS320C6416T DSP for baseband processing and compatibility with legacy waveforms • MPC8541E general purpose processor for baseband processing and control • Gigabit Ethernet via rear panel • Support for Green Hills INTEGRITY Real-Time Operating System with MULTI and Wind River VxWorks with Tornado • Spectrum’s quicComm API hardware abstraction layer • Optional Software Communication Architecture (SCA) Core Framework • Optional CORBA Object Request Broker (ORB)

A single card “RF to Ethernet” solution covering 800 MHz to 2.4 GHz that can be integrated into your terminal system and connect to an existing power amplifier and LNA or LNB antenna assembly • Designed to support commercial standards such as INTELSAT Business Services waveforms (IESS-309 and IESS-315), DVB-S/S2 and INMARSAT BGAN • Designed to support Tactical Military SATCOM (MILSATCOM) waveforms, including the MIL-STD-188-165 and MIL-STD-188-181/182/183 • The single board radio module is designed to operate at less than 15 W combined for RF, IF and baseband signal processing • Modular hardware and software architecture that can be rapidly customized to meet your specifications in as little as 90 calendar days • Operates at temperature ranges from -40 ºC to +70 ºC and altitudes of up to 10,000 ft